![]() It is transversely mounted to a chassis crossmember (left-to-right). The combination fuel filter/pressure regulator is located in front of the fuel tank and above the rear axle. Filters should only be replaced if a diagnostic procedure indicates to do so. They do not require normal scheduled maintenance. Both filters are designed for extended service. Is something incorrect or missing? Please get in touch with us and we’ll fix it!Īll WJ models have two fuel filters, a strainer filter at the bottom of the fuel pump module inside the fuel tank and one exterior filter within the fuel pressure regulator. We have organized as much information as we could find into a helpful article below. There's plenty of room for the factory single exhaust, and the rear axle is miles away from the back of the tank, so if we ever do get a wild itch to add 1-ton axles or huge dual exhaust in this Jeep we know we won't have to make fuel tank modifications to accomplish it.Welcome to the in-depth page on WJ Generation Jeep Grand Cherokee fuel filters. But until then, we have the tank up and held in place with four of the eight mounting holes, and we're pleased to say the fit is perfect with no interference at the bottom of the floor. We'll have to drop the tank one more time to finish hooking up our fuel system after the engine swap begins, so we're going to wait until that time to hook up the filler and vent as well as welding the nuts to the inside of the frame to make install and removal much easier. Then, we pulled the tank back out and finished drilling the holes and then bolted the tank back in. Once it was up tight into place, we measured each side to make sure the tank was centered side to side and from the rear crossmember and then drilled eight small pilot holes through the frame at the center of each tank bracket.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |